Nat configuration is required for systems on the LAN to have access to the internet. To configure a dhcp server on a Mikrotik router, click on IP>dhcp server>dhcp setup and follow through.

Without a dhcp server, assignment of IPs can become a fulltime job, and if not properly done, there will IP conflicts. In most cases, a dhcp server will be required to help lease out IP addresses to connected users. To configure a default route on Mikrotik, click on IP> route> enter gateway to destination 0.0.0.0/0 The router must be assigned a default gateway, also known as default route, to get to destinations beyond the ISP’s network.

To assign an IP address manually, click on IP>address>add>enter address and subnetmask. See here for how to configure a Mikrotik router interface as a dhcp client. If the ISP has dhcp enabled, then the ether1 on the Mikrotik can be configured as a dhcp client, otherwise, an IP will be configured manually. In most cases, the ISP connection goes to ether1 while the LAN connection is plugged to ether2. Before the assignment of IPs, the WAN and LAN interfaces must have been chosen. To set system password, click on system>password>leave the space for old password blank and enter new password twice.Īt the most basic level, two IPs are required on the router to successfully connect users behind a Mikrotik router to the internet. To change username, click on system>users>double click on the admin user and change username from admin to something else. Users are advised to change these settings. Mikrotik routers have default username as admin with no password. Though not compulsorily required to connect a router to the internet, it highly recommended for the security of your network and network device. system identity set name=timigate Username and password To assign a Mikrotik router an identity, simply enter the commands below. It allows an administrator easily identify a router. This is not part of the requirement to connect a router to the internet but is recommended especially when managing multiple routers. Configuring system identity is part of the administrative configuration and is not compulsory. System Identity is to Mikrotik what hostname is to Cisco. How to configure a Mikrotik router System Identity These tasks, some of which are not compulsory, are listed below and will be looked into one after the other.

There are seven basic configuration requirements that must be met on a Mikrotik router to provide internet access to all connected users.

Mac vpn setup for mikrotik